1. ATTENTION EXISTING USERS: If this is your first visit to the new forum, you must reset your password. Please go to http://cobrakitcar.net/lost-password to reset your password.

    Dismiss Notice

seats

Discussion in 'General Comments and Questions' started by tveazey, Dec 13, 2014.

  1. tveazey

    tveazey New Member

    Well I am having a problem finding seats. I am not a fan of the barrel seats that Brian sell with his kits. in fact I did not get his interior. I ordered some seats but they are to wide on the top side and they touch the door. so after a few closings it will cut the seats. Will any of you out there share what seats you have and a pic of them in your car I need some bad. I am about to take it to my upholstery guy and I don't have seats that I can use. Thanks for your help in advance.

    Tony
     
  2. Luce

    Luce Member

  3. tveazey

    tveazey New Member

    So they fit good. the ones I have now are similar to yours but in leather. and they are about 2 inches to wide up top. I would love to see some pics of your car with the seats. front, back and in the cockpit.

    Thanks

    Tony
     
  4. tveazey

    tveazey New Member

    LOl never mind I noticed the thread at the bottom of your reply. thanks your car looks great. I like the interior. hell I love the car.
     
  5. TexasDoc

    TexasDoc Member

    I bought the Proscar seats from Summit. http://www.summitracing.com/parts/sca-80-1615-51

    They were about 1 1/2 inches too wide near the top of the doors. They fit fine into the seat pan. My upholstery guy took off the vinyl, narrowed the fiberglass back by about 1 inch per side, then re-upholstered the entire seat in leather. I like the taller seat, with the shoulder belt holes.
     

Share This Page